Архив SW

[atnet]

I have old kind of adapter - so, if I understand right, it's without MM-CAN. Does it mean that my adapter will not be able to do above mentioned things?
If he doesn't, then pls replace with new kind of adapter with MultiMedia-CAN

It can, but you need to connect it to adapter with the wires. I will make a scheme soon.

Будем ждать, думаю для многих актуально если адаптер можно самому доработать !

[Universe]

It can, but you need to connect it to adapter with the wires. I will make a scheme soon.

Будем ждать, думаю для многих актуально если адаптер можно самому доработать !

Адаптер не надо дорабатывать. Просто соединить по схеме и добавить резистор. Короч, ждите, вечером сделаю.

[oscarboiro]

Hi, congratulations for new version.
I download new version of ucds and new adapter firmware.
but i have one problem, after update, mi adapter have version 10
in old version of ucds work correct, but in new version not possible cdonnect in can mode to work in ucds.
any sugestion, is posible download ather firmware?
regards

[gizmowai]

Try update with 1.21 and yo dont have problem

[mayak]

Oscar,
check this resistor: http://www.ucdsys.ru/forum/viewtopic.ph ... 1541#p1545

[mayak]

I tried to reprogram firmware of the adapter:
SelfProgramming Write Memory Started... - after about 2 minutes it finished, but firmware version remained 10 !!! (((

[mayak]

I failed to update firmware of adapter:

SelfProgramming Write Memory Started...
SelfProgramming Write Memory OK!
SelfProgramming New Flash Initialisation...
Error! Version of firmware not acceptable...

it took about 2 minutes

After next trial it was like that:

SelfProgramming Write Memory OK!
SelfProgramming New Flash Initialisation...
Wait...!
SelfProgramming OK! FW Version: 10

[oscarboiro]

Hi Marcin, thanks for your sugestions.
y see link, amd i have resistors of the first picture.
you have the same proiblem? or reply my scrennshot sended to whats app?

regards

[oscarboiro]

i try now to download firmaware and update, and now have firmware 11.
ucds 1.22 great works

regards

[gizmowai]

How you update?

[mayak]

I tried again, but nothing changes - I have still v 10

[gizmowai]

Mayak if you have 1.21 Try update with this versión and the New firmware v11.

[mayak]

Mayak if you have 1.21 Try update with this versión and the New firmware v11.

I tried, but doesn't work

it writes:

CRC - 004A1775
Flashing firmware procedure started...
SelfProgramming Initialisation OK!
SelfProgramming Erase Memory OK!
SelfProgramming Write Memory Started...
SelfProgramming Write Memory OK!
SelfProgramming New Flash Initialisation...
Error! Version of firmware not acceptable...

[mayak]

Непроходимо обновить прошивку Адаптера до 11 версии

Толя помог через тимвьюер.
Спасибо ему!

Does anyone can help me?

thanks in advance!

[NEIF]

подскажите пожалуйста калибровки для чип тюнинга надо гдето скачивать или они в программе уже есть и где найти файл обновления прошивок