C346 BCM update

[silverstreak2006]

Just some feedback of experience of this issue experienced.

I had to rollback a BCM update I performed as part of a check on my 2018 Focus ST.

Software was already updated once to JV6T-14C094-AB and worked as expected.

I updated this to JV6T-14C094-AE and then discovered I had no heated screens or AC signal send. I check the Asbuilt and Direct config, and could see the settings, but as soon as I rolled this back using the VBF loader all was restored.

If anybody else experiences this then using the load without researching, the files required are:-

JV6T-14C097-AA (SBL)
JV6T-14C094-AB (the original update)
JV6T-14C094-AB
JV6T-14C094-AB

The only file updated was JV6T-14C094, the two bottom files remained the same, could these have required updating to to accommodate maybe?

Anyway I hope this helps anybody troubleshooting.

Thanks

Pete