UCDS Forum

Hello, after flashing the PCM the ignition counter is 0.
Is it possible to adjust tis value?
Thanks.

HI

This is the parameter in PCM - would be great if the developer would enable this to write it with UCDS
M9_08_IGNCNTR_A
M9_08_IGNCNTR_B

Extraction from Ford Instruction:

Section B: Determining the Existence of an Aftermarket Calibration
This section should be used when the vehicle being serviced currently has or possibly had an aftermarket PCM calibration. It is recommended to also conduct this step on tow in vehicles with unexplained engine damage.
B.1 Ignition Counter
1. Pull Mode 9 data with IDS 2 Compare ignition counter (IGNCNTR) value to vehicle service history. If counter value is abnormally low and there is no history of a recent reflash, investigate for an unauthorized reflash and signs of aftermarket tuner connections. Refer to Chart 1.

Is this already possible?

Developers are investigating this if this will be possible?

Any Update on this? Especially for Focus MK3?!

BR.