Hi,
I have done an update of Halogen to Full Led reflectors. I performed several steps listed below:
- installed LED Headlamps
- installed new HCM
- installed leveling sensors on front and rear wishbone
- configured all as i found on forums
Led light
DRL and low beam work even with no HCM instaled but High beam is not active ( it display blue icon when press trigger and also when automatic lights are active but no light is present at all on the high beam
High beam when HCM is connected can be turn manually by the handle under the stering wheel but it does not work autoamatically as only blue icon is present then on cluster display but no light is present.
Does anyone saw anything like this? mabe it is caused by resistance settings somwhere that i was not aware of.
I will be greatful for any help.
Kind Regards
Rafal
full led upgrade failed
Модератор: DanMc85
-
- Сообщения: 1
- Зарегистрирован: 28 мар 2018, 23:04
-
- Сообщения: 69
- Зарегистрирован: 01 фев 2018, 23:16
Re: full led upgrade failed
Have you try to look on a car there has LED to check codes?
Have you put in software on HCM?
it's a mondeo?
Have you put in software on HCM?
it's a mondeo?
-
- Сообщения: 27
- Зарегистрирован: 14 май 2016, 22:55
Re: full led upgrade failed
Hello !
Did you also make the settings for LED headlights in the IPMA?
I have installed the LED as standard, with my IPMA was a configuration error because there were the same symptoms as you!
Did you also make the settings for LED headlights in the IPMA?
I have installed the LED as standard, with my IPMA was a configuration error because there were the same symptoms as you!