UCDS Forum

Hi Guys
I have enable heater on a Mondeo mk5 2017, and it works. When you tell it to heat now, but when it's programed, it will not turn on??
I have enable FFC in IPC and chance type in AHCM from 01 to 02, Chance in PCM to heater with timer and remote

Anybody there has played with is?

Best regards
Lars

Didn’t even L ow we had an aux heater

dragunov писал(а):Didn’t even L ow we had an aux heater

Yes can see you maybe have it too

How?

Hi Lars

I have the same problem om my retrofitted OEM FFH on my mondeo mk4. Please share if you fin a solution

Regards Tommy (also DK)

When You programmed "webasto" in IPC You must remember,that is the departure time, not time which webasto turn on

Hi yes I know, but it will not to turn on, next step is to try with a GSM modul

dragunov писал(а):How?

If you check with ucds to see if you have AHCM modul, then you have heater

larsmdk писал(а):Hi yes I know, but it will not to turn on, next step is to try with a GSM modul

I went that way to. I used a GSM module from Danhag.de (I have a spare one actually, you can try it if you want. I presume your from Denmark )

Fer писал(а):

larsmdk писал(а):Hi yes I know, but it will not to turn on, next step is to try with a GSM modul

I went that way to. I used a GSM module from Danhag.de (I have a spare one actually, you can try it if you want. I presume your from Denmark )

yes I'am from Denmark

Hello,
I'm from Germany, so excuse my bad english.
I own a Mondeo MK5 2.0 diesel for 5 months. It is a reimport from Denmark, so he also has the diesel heater.
I got a manual to use this as a heater, but still without success.
1. BCM DE2B AHCM available cfg- present - was already set
2. IPC DE00 FFH - enabled - I have set, parking heater is in the display selectable
3. FCIM DE00 - vehicle contains a fuel operated heater - was already set
4. PCM DE00 Reserved 8. Here it should be that of 0E59 to 0F59 to be made. With me a 0 is registered. I can only enter numbers in this field.

How did you do that? In the PCM, the following must be set under DE01: FFH FFPH and a "with timer, petrol" option. On FFH it was on FFPH and "with timer" I tried it, get it set in the display, but the heater shows no function.

I already thank you for your help.

Holger

Update:

In AHCM I hace set it to 02.
Now it starts when you tell to heat now. But the timer will not run...

sorry....postet twice

Yes true the timer does not work, so now i mount a GSM modul on the car and control the heater that way, then it works

and...wich modul do you use?
Can you tell me when it works..?

Holger