UCDS Forum

Hi, I've written new calibration files to HCM. After the registration, the headlamp error, service!
Detected errors can not be deleted.
Does anyone know what this might be? thanks
Ford Focus 3 (2015)


After upgrade modul HCM:

---------------------------------------
DTC Error read - :
Module Name: HCM Network: HS-CAN Protocol: GGDS
DTC Errors: 2

U0121 - Lost Communication With ABS Control Module

U0121 - Lost Communication With The ABS Control Module
Ext.Status: 08 - Control Limit Exceeded.(DTC) Present at Time of Request.
00- Error status not found in base....

U0140 - Lost Communication With Body Control Module

U0140 - Lost Communication With BCM
Ext.Status: 08 - Control Limit Exceeded.(DTC) Present at Time of Request.
00- Error status not found in base....
---------------------------------------

Is this a UCDS problem ???
Module calibration does not work ...
Even despite the error message, HCM has come to life. Error message on LCD disappeared !!!

USE SPECIAL PROCEDURES IN FOCUS 3 SECTION > HCM