UCDS Forum

Hello,
I need to change PCM configuration in Transit Custom 2016 2,2TDCI (SID208)
PCM was repleaced because original is dead (mainboard is broken)
I updated soft by IDS writting VIN of the car but I still have DTC U2101:86 (configuration incompatible)
Could you help to resolve this problem?

To additional clarify the problem.
Installed ECU is from car which had Start/Stop system.
This car doesn't has this system and probably this is reason of configuration error.
In my opinion solution is writing soft without START/STOP system or another way to change configuration.
Thank you for any sugestions.

PATS information is stored in BCM and PCM in Transits. If you replace PCM you need to reinitialise PATS and sync the module.

PATS is not topic of this post!
The ECU was reinitialised and synchro is done.
Engine is working but there is problem with INCOMPATIBLE CONFIGURATION in PCM!
Engine error is still active on the dash.