UCDS Forum

My US APIM [F113] GB5T-14G371-BFC getting dead after update. I try VBF uploader but no lucky. It stop on GB5T-14G375-BA file.
I tried this calibration but can not update,
GB5T-14G376-AA
GB5T-14G374-CB
GB5T-14G379-AA
GB5T-14G375-FA
GB5T-14G379-BA
Any idea?? Thanks

Its module from Edge/Mustang, i think module not see igniton signal (if you make on table)

kroligoff писал(а):Its module from Edge/Mustang, i think module not see igniton signal (if you make on table)

Yes, it is. Thanks so much

I guess your CAN-BUS must be set to HS1 not HS-CAN

hutangjun писал(а): ↑21 май 2020, 03:42 I guess your CAN-BUS must be set to HS1 not HS-CAN

It's US Fiesta. It don't have HS1 Can

khacduy писал(а): ↑04 май 2020, 14:31

kroligoff писал(а):Its module from Edge/Mustang, i think module not see igniton signal (if you make on table)

Yes, it is. Thanks so much

does it work now

fordsmaxtcdi писал(а): ↑30 май 2020, 05:10

khacduy писал(а): ↑04 май 2020, 14:31
Yes, it is. Thanks so much

does it work now

No, it doesn't. It's not working