UCDS Forum

hi
i have Focus3 MT2.0 in china.
i want open "ASL". use clone VCM+IDS85.
include cruise and lim button in my left switch.
i've updated the BCM to the latest firmware.
if open "ASL" show two error in DTC.
if clear DTC,this two error still show.
look pic. use UCDS can open this function?how to buy?
maybe i need open some software in BCM or IPC? should i do?
i'm english is very very poor... please don't laugh at me

There is nothing to laugh about here.
please take a photo of your steering wheel cruise buttons.

Universe писал(а):There is nothing to laugh about here.
please take a photo of your steering wheel cruise buttons.

my car already have cruise button,i changed to have lim function switch.all wires have

hello ?...

Cruise and ASL function must be enabled together.
Are you do this correct?

Darkleo писал(а):Cruise and ASL function must be enabled together.
Are you do this correct?

yes.
but i have a new discovery.
i found this pic.


but my car only have cruise button.
pin
1 - 15
2 - 10
3 - 16
4 - 8
5 - 7
maybe switch 1 2 pin,can open asl?

Hi I know that in our country those peoples? who install cruise control, add 1 more wire for correct working. May this wire for asl ?

Please look forums... Your situation i think have solution.

Darkleo писал(а):Hi I know that in our country those peoples? who install cruise control, add 1 more wire for correct working. May this wire for asl ?

Please look forums... Your situation i think have solution.

I've got it covered.the internal resistance of the switch has been modified，i fix it!


Also, I want to buy a UCDS. But I wrote a lot of letters tell me Out of stock?I can order it?