UCDS Forum

Helo
Today after programing PAM module Mondeo Mk4 2007 , parking sensor stop working and no visualization in convers+ . Reprograming give nothing.
Version UCDS v1.26.003

Try
We cant relive module PAM

After UPDATE ..... PAM DEAD



Tomek

zaqik писал(а):http://wiki.ucdsys.ru/doku.php?id=fordm ... mondeo_pam

It does not work ! module PAM is dead

I use file in attachment and every module works (7 - 10 pieces) ... last module in UCDS 1.25.013 yesterday

zaqik писал(а):I use file in attachment and every module works (7 - 10 pieces) ... last module in UCDS 1.25.013 yesterday

Problem is from UCDS 1.26.xxxx .......

Try and send message
OK ?

You USE PCM update for PAM ..... joke

attachment was changed

Friends
Today I tried once again to program the PAM module and the module is still dead The customer is waiting and there's nothing I can do about it

kirhof писал(а):Friends
Today I tried once again to program the PAM module and the module is still dead The customer is waiting and there's nothing I can do about it

Did you try FORCE programming?

Did you try FORCE programming?

Yes

Universe писал(а):

kirhof писал(а):Friends
Today I tried once again to program the PAM module and the module is still dead The customer is waiting and there's nothing I can do about it

Did you try FORCE programming?

Hi .
many people had this problem .
PAM module dead ....... after update inside PAM no firmware .
I must send PAM for programer programing .
Now I use IDS ....
something was wrong in new UCDS update ,.... in 25.003 all working good with PAM programing.


tom

any idea to alive a dead PAM modul?

Hi, please try update in 1.26.005, we found problem

forced programing can realive dead module?

twincept писал(а):forced programing can realive dead module?

Normal
Try