UCDS Forum

Im Trying to install a Original Ford MFD Screen in my prefacelift 2010 Fiesta.
I have installed the screen and edited the asbuild data.
Also i changed the pinout of the screen: pin 7and9

The screen turns on and i can navigatie with the buttons of the radio.

Only there is no sound and no possibility to receive radio stations.
Also CD in the cd player is not detected.

Can anyone point me in the right direction?

picture is example.

do you have CD from facelift? try it

Thanks for your response, not yet.
I do have a focus mk3 radio but it has a sync connector.
Also I have a 2008-2010 loom

> Im Trying to install a Original Ford MFD Screen in my prefacelift 2010 Fiesta.

"new" MFD from FF3? it does not work in FFi7 (different fw in FCIM between FF3 and FFi7)

Take a photo or write marking on the rear side
example: хххх-18B955-xx

Or modules poll log, find FCDIM

Tried the screen in a facelift fiesta 2013. It was plug and play.
This car was not fitted with Bluetooth or sync.

Iam looking for a facelift fiesta vin with navigation and bt/vc non sync.
This So I can lookup electrical scematic.

Is it impossible to flash fdcim with correct firmware?

The fcdim is not detected in my car, but i made a picture. It is detected in the facelift fiesta

> Iam looking for a facelift fiesta vin with navigation and bt/vc non sync.

in my opinion facelift fiesta has only sync ... BTmodule with USB is for prefacelift

I found a facelift fiesta with bt/vc but without navigation.

f1bt-18B955-da is modern type for fiesta and kuga ... it is only for sync

Thanks for responding, is there annyway to reflash screen to bt/vc?

Today installed different hu from fiesta facelift, sound works, gps works, only no Bluetooth/USB and time.

> is there annyway to reflash screen to bt/vc?
no way ... screen with navigation is only for sync

Ok thank you, wil try to find a bt/vc from a focus.

I know it is an old request this here but i have been working with fiesta 2014 with after mount navigation there are different sync module in the one with factory fitted VC/BT
and the ones with out navi if you fit navi in there is no guidense from navi because it goes throgh VC/BT module and there is another difference the BT module in the cars with navi has usb connectors and with out just one usb in both cars it isjust one that are used
it is not as in focus and kuga where it isto pull 2 ekstra wires from display to radio and so the guidence voice is there
i dont know if this can help any one
rgds sev

I installed SYNC3 into car ... but now I cannot change settings of powerfold mirrors, lane change indicator, active city stop and alarm on exit. My sync configuration: But there are missing in "vehicle settings".
Does anyone know where the problem is?