UCDS Forum

I tried to use the Direct config function in UCDS v2.0.001.008 today but every function i try to use fails and i get "No answer on SEED request: Error: SubFunction Not Supported [0x12]"

this seems to happen no matter what module i try the Direct configuration function with.

I don't think i got this error in v1 of the software when i tried it?

Please enable Logging and give me

enable debug or can bus logging?

Can Logging

Hi .How to reset milage on Ford fiesta mk7 2010, I use ucds to read ipc, but the message field shows "diagnostic request done. Seed not coorect!"