Ford Fusion 2017 bricked BCM - Wrong conf file loaded

[kroligoff]

Set position on DE00 and programm show error on write, and provide screen

[natcorporation]

Error is : Failed to write block DE00 of data ... Error: Conditions not correct [0x22]

This is error for every block change is configuration now.

I this maybe this is problem - they haven't ignition on.

I Can read configuration but can't write.

Thanks for interesting with my problem.

[kroligoff]

I think need reprogram key again (over EtisIDS or IDS)

[natcorporation]

But strange thing is this remote working - something data from key - is ok in bcm. Do you have info what eeprom or processor is inside this new bcm ?

[natcorporation]

I try to reprogram key with SKP900 - This do keys without problem I program few fusion's for keys but on this - I can't turn ignition on - communication failed on skp900. Maybe I must turn ignition on in emergency mode - send 12v on fuse and goes up systems. Friend sev611 write on post 2 in this thread. Maybe this is good idea.

[natcorporation]

I buy account on FJDS Ford motorcraft service - USA for 2 days - reprogram BCM with Programable module Instalation - BCM - everything fine but configuration not upload done - Maybe anybody have solution ?

[kroligoff]

Vehicle not started?

[auto-hentzschel]

if you changed the BCM, you need to go to PATS and reset the parameters and relearn the BCM to sterring colum.

[natcorporation]

Ok

I think dump in eeprom - motorola is fucked.
What I do now ? I read memory from motorola mc9s12xs256 0m05m - dflash , and pflash

and read mpc5607b - cflash, dflash, cshadow.

Today I upload pinout to read memory without disassembling all BCM - in are two boards

Anybody Can look on dumps and check it ?

In attachments I add few photos MCU and dumps readed from car with UCDS and VVDI prog from memories.

[natcorporation]

READED MCU DUMPS

[natcorporation]

Direct Config all read

[natcorporation]

Any have idea - how to run this car ?

Please help

[natcorporation]

Car works - everything fine - original FORD interface and online programming not works - is only one solution. Who has problem write to me. Thanks for everyone for help.

[Szutek]

If you can you could share solution for future. Maybe someone will have the same problem.

[Kingsammy]

@natcorporation: So please tell us your solution.