Lost RCM IMPA and

[yoda2]

Hi,

Worked on Ford Custom 2013. Wanted to update the whole care. Started with the IMPA module, then some other module and than the RCM.

This was the situation before

flashoverzicht_voor_flashen.jpg

And this the situation after flashing

flashoverzicht_na_flashen.jpg

Is there any chance in rehabilitation of both modules? If so does someone know how to proceed?

Best regards,

yoda2

[yoda2]

Did some tinkering on RCM module.

Found out that the update version BK2T-14C028-BA.vbf is 334 kb on disk, once loaded in UCDS it says 0 bytes. Tried downloading the file several times, result is the same. See screenshot below

photo_2020-02-01_17-29-22.jpg

Anyone knows how to fix this problem? I would like to have the RCM unit back up and running.

[kroligoff]

Try Restore original firmware

[yoda2]

Hi,

Thank you for your reply. Via the telegramchat, Sergey S told me that the file BK2T-14C028-BA did not have the correct omit zone. He gave me an adjusted file. With that file and UCDS I managed to make the RCM unit approachable.

From that point on I was able to connect to the RCM unit to read fault memory, erase fault memory etc. However now I have 4 faults left.

RCM_foutcodes.jpg

I did direct configuration (loaded as built from ETIS) -> "write to module" (also tried with "reset module" on forehand) -> UCDS says "All operations Done! Errors: 0". If do "read from module" every configuration setting is gone. From the telegramchat I understand the eeprom is damaged. I geuss it is non-repairable in a software manner and I have to buy a new/used module.

RMC_data.jpg

What do you exactly mean bij original firmware?