Updating Convers+

[bigi]

I have installed a mk4.5 (Facelift) Convers+ dash in my PreFL (mk4) Mondeo to replace the original PreFL Convers+ instrument panel.

I have applied the update through UCDS using the PreFL (2007>2010) update wizard, which has updated to BS7T-14C026-CG/BS7T-10849-XH - but this is not the most recent ROM as it still doesn't provide the latest features.

However, if i go through the FL update wizard (2011>2015) and load the module list from my car, the IPC has an update available to CS7T-14C026-CG/CS7T-10849-XH (which is the latest version). Would it be safe to update the dash with this version? Technically, the dash is from a FL, the car isn't

[zaqik]

you cannot use standard fw for preFL or FL convers ... you need special fw for FL convers in preFL car
(standard FL convers in preFL car - airbag icon will be light)

[gsmunlock]

Hello. I have convers+ FL . IPC BS7T-14C026-CE , Rom 1218 , I had updated to BS7T-14C026-CG, Rom 1304.
Question what names of files must be used to get Rom 1412 ? Possible update to rom 15xx ? If rom 15xx can be done so what files names must be used?

[leszcz33]

what names of files must be used to get Rom 1412 ?

CS7T-14C026-CD
CS7T-14C026-ED

[gsmunlock]

Bootload need flash as well? Bootloader will be good 7M2T-14C025-AA ? Or need different one?

[Artist]

Do you have a UCDS?
Use the update wizard and select the latest version of the calibration files.
The bootloader is the same for all convers + Ipc.

[gsmunlock]

I do not has ucds but I have original els27 v3.0 and using forscan.

[Artist]

In this case, contact the Forscan forum or contact els27 support.
I'm surprised this forum is not locked for UCDS clones and other cables ...
When registering, it was necessary to state the UCDS serial number, or to activate it via the original cable.
I could give you all the answers, but I won't.
By the way, the Forscan beta test version supports flashing modules, have you ever tried this option?

[gsmunlock]

yes, betta flashing works nice. I have flasher convers+ from 1218 --> 1304 , but forscan server does not offer higher firmware version
want to get minimum 1412 to get engine temperature on screen and clock too. I interesting in stock firmware only. I do not think it is big crime:) I am planning buy ucds with extended licence little bit later.

[Artist]

Read your posts and replies again. You have received all the information you requested ...

[gsmunlock]

Today done my convers+ v1304 --> v1507 by stock firmware update / i have got what i wanted . Thank you everybody for help.

[zaqik]

v1507 has different icons, use v 1412

[fordsmaxtcdi]

Hi

Mondeo rom1302
which is the correct choice 1 or 2 in the picture
Thanks

123.png

[Artist]

Bad question! You do not specify the type of car.
Facelift or prefacelift?
Installed to old cars means you have a new convers+ and you want to put it in the car pre-facelift. You will get modified software for the airbag, which would otherwise be permanently lit!

These are cars up to and including 2010.
After 2010, the cars are facelift.
So if you have a Mondeo / S-Max / Galaxy after 2010, upload the option # 1 you marked