UCDS Forum

Hi members.
I need some information. Would it be possible to connect UCDS to ford Mondeo IPC on bench using a harness or by making one harness .

If yes would appreciate of any one can share the wiring diagram or link to get one connector.

Thanks in advance

This should be the standard Ford IPC connector. https://wiki.ucdsys.ru/doku.php?id=ucds:obd

What year is your Mondeo?

Below is for 2019 Fusion Hybrid, should be the same for 2013+, this is connector view that plugs into the IPC. Not sure if your Mondeo uses the same connector.
From USB OBD connector to IPC:

OBD 3 to IPC 25
OBD 11 to IPC 26
OBD 5 to IPC 5 (and also to negative [GND, black] of 12V DC bench power supply)
OBD 16 to IPC 21 (and also to positive [+, red] of 12V DC bench power supply)

My Car is a 2020 Fusion Titanium AWD .


Thank you for the information

May I ask why you're doing IPC bench programming on a 2020 Ford Fusion?

What year is your Mondeo?

Below is for 2019 Fusion Hybrid, should be the same for 2013+, this is connector view that plugs into the IPC. Not sure if your Mondeo uses the same connector.

Dear Members , I have connected the ups to the obd with a power source . and connected the ucds to the obd.

what am i missing in this circuit to keep the ipc in turned on mode ?

Hi mayurreddy - did you figure it out? Have you a 12v supply hooked up to the IPC as per "scn101" instructions?