UCDS Forum

Hi

Is it possible to remap PCM of 1.0 ecoboost 100PS Focus MK3 to a higher power using UCDS?

Thanks!

In 1.25.009, inside the MotorSoft section there are some PCM chip tuning firmwares.
But there is nothing for 1.0L ecoboost 100PS engine.
May be something will be added in the future.

Can someone please reply if this is the only way to remap/chip tune via UCDS?

You can change 1,0 eb 100ps to 125ps without using Motorsoft

Thanks for responding. This is my first car and I am new to these kind of mods

It would be really helpful if you can explain in more detail or please provide some resources with such info.

be careful - engine head in 1.0eb 125 is different comparing to 1.0 100 and many 1.0 100 are without start-stop (market dependent) while all 1.0 125 have it = DTCs

Thanks for your concern.
My car is 1.0 ecoboost 100PS with start/stop and manual transmission.

Do you know any possibility to remap this engine config to a higher one?

send me VIN on priv

PM sent. Thank you!

Hello,
I also want to switch to the 125 ps map. can someone explain more exactly how it works?
Thank you

What about the 125HP version to 140HP?

@twincept How to change the 100HP map to 125HP map if u don't need to use Motorsoft?

My car has a 1.0 ecoboost 100PS with auto start stop.
I uploaded PCM with the following 125PS engine files.

SBL: CV61-14C273-CB
Config: CV61-14C204-AVB (there is also a newer version with AVC but I haven't tried)

The 125PS has 6 speed transmission but works with 5 speed 100PS. The only annoying thing is the 6th gear upshift indication in IPC.
For me the fuel economy was bad after switching to 125PS.

Remove the shift indicator in UCDS

also cruise control will not work after that change

Of course, shift indicator can be disabled!

No problem with Adaptive Cruise Control for me

Hello. I'm new. Could you explain step by step how to increase power? I have a full license and V3 adapter.
Thank you.